Arrington Performance is moving to Brighton, Michigan!

All new installations will be performed at our shop in Brighton -- with the same great service and Mopar mastery. In the meantime, we know we have been hard to reach on the first try. Please be patient -- your business is important to us and we are getting back to those messages as quickly as we can.
The easiest way to make sure your message is captured is to email us at sales@shophemi.com. Thank you.

DId you know about our Hellcat 426 short block?
Need 1000HP? - here you go.
TRAKit at Ultimate Street
Car Challenge in NOLA!
Arrington Powered.

Watch the Arrington Performance Intro    

Exhaust Clamps, Gaskets and Accessories

Complete your exhaust system install with the parts and pieces you need and keep from leaking exhaust gas with a new set of gaskets. 
Filter Results:
 
Sort By:
 
  7 products
American Racing Headers O2 Extension Harness Kit. This kit extends your stock oxygen sensor wiring to reach the new O2 sensor locations on ARH. 
Product Rating:
MSRP:$131.88
SKU:ARH-CHRYEXH
Dimensions:8x8x15
Weight:5.0 lbs
Price:$105.50
BBK O2 Wire Harness Extenders - A must when Installing Full Length Headers on Dodge applications. Factory connectors allow simple installation of O2 sensors due to fact that the locations are moved on Full Length headers. (Sold in Pairs)Factory OEM connectors and heat protective sleeves make installation a snap.Connectors May require the small directional tabs to be removed on the ends of the connectors to fit some applications.Currently These Extensions Only Work For 96'-04' Dodge Applications 
Product Rating:
MSRP:$49.99
SKU:BBK-1117
Dimensions:8x6x5
Weight:8.0 lbs
Price:$39.99
Dodge 6.1L Hemi Exhaust Gasket 
Product Rating:
MSRP:$53.88
SKU:COM-HMIEG
Dimensions:2 x 18 x 3
Weight:2.0 lbs
Price:$43.10
Patent-pending, Venturi-effect, tapped exhaust clamp for obtaining accurate lambda measurements in non-cat autos or other engines. Innovate Motorsports PN 3728. 
Product Rating:
MSRP:$86.90
SKU:IVM-3728
Dimensions:8X8X5
Weight:2.0 lbs
Price:$79.00
The Bosch LSU4.2 wide-band O2 sensor (shipped as part of the LM-1 kit) is rated to operate at an exhaust gas temperature of < 1300 degrees (F), and a sensor housing temperature of < 900 degrees (measured at the bung) for maximum accuracy and control. When either of these operating temperature ranges is exceeded, the sensor can no longer be accurately controlled. Further, operating at or over these temperatures for any length of time can significantly reduce the lifetime of the sensor.... 
Product Rating:
MSRP:$97.90
SKU:IVM-3729
Dimensions:8X8X5
Weight:1.0 lbs
Price:$89.00
Sold each. If ordering singles please specify left or right. Order 2 to receive a pair.If your headers are leaking replacing your 5.7L HEMI 2005-2008 header gaskets with OEM units is a good way to fix it. These Mopar exhaust manifold gaskets are much higher quality than the ones that come with most aftermarket headers. We recommend picking up a new set when installing a set of long tube or shorty headers. By using top quality Mopar gaskets you reduce the risk of developing an exhaust leak.... 
Product Rating:
MSRP:$31.99
SKU:MPR-53013944AA/53013943AA
Dimensions:3x10x20
Weight:2.0 lbs
Price:$42.50
If your headers are leaking replacing your header gaskets with OEM units is a good way to fix it. These Mopar exhaust manifold gaskets are much higher quality than the ones that come with most aftermarket headers. We recommend picking up a new set when installing a set of long tube or shorty headers. By using top quality Mopar gaskets you reduce the risk of developing an exhaust leak. Can be used with JBA, Kooks, Dynatech, and other aftermarket headers.  
Product Rating:
MSRP:$46.00
SKU:MPR-05038098AA/05038099AA
Dimensions:3x10x20
Weight:2.0 lbs
Price:$41.50